What dryer vent installation typically costs
| One dryer vent | $589–$1,189Depends on the length of the run and the wall it goes through. |
|---|
Typical prices in Metro Vancouver and the Fraser Valley in 2026, before tax. They are a guide, not our quote. Too much depends on your home to price these jobs unseen, so your price is set on site, in writing, before any work starts.
When you need it
- The dryer vents into a crawl space, attic or garage
- White plastic or foil flex duct behind the dryer
- Laundry is moving, or a gas dryer is being installed
What changes the price
| Length and route | A short run through an outside wall is simple. A long run through floors is not. |
|---|---|
| Wall material | Coring through concrete or stucco takes longer than siding. |
| Booster fan | Runs beyond the dryer's rated length need a booster fan. |
What the job involves
- Plan the shortest route to an outside wall.
- Core through the wall and fit an exterior hood with a damper.
- Run smooth rigid metal duct with as few bends as possible, with joints taped and not screwed.
- Connect the dryer and check the airflow at the hood.
- Time on site
- Usually 2 to 4 hours
How pricing works for this job
There is no one price for dryer vent installation, because the factors above change it from one home to the next. It starts with an on-site estimate for $269. A Pure Mechanical Group plumber looks at the job and gives you a price in writing, good for 30 days. Approve it and the $269 comes off the price. If you do not go ahead, the fee covers the visit. Anything found once work has started is priced and approved before it is done.
Call 1-800-604-0631.
Questions people ask
How much does dryer vent installation cost in Metro Vancouver?
One dryer vent: $589–$1,189. Typical prices in Metro Vancouver and the Fraser Valley in 2026, before tax. They are a guide, not our quote. Too much depends on your home to price these jobs unseen, so your price is set on site, in writing, before any work starts.
Why not flexible duct?
Foil and plastic flex duct trap lint in every ridge, and they crush behind the dryer. Rigid metal stays clear and is what manufacturers call for.
How long can a dryer vent be?
Each dryer has a maximum length in its manual, and every bend shortens it. Beyond that, a booster fan is needed.
Can a dryer vent into the garage or attic?
No. It sends moisture and lint into the building. A gas dryer would also send its exhaust there.
Is the estimate free?
No. A Pure Mechanical Group plumber comes out, looks at the job and gives you a written estimate. Approve it and the $269 comes off the price. If you do not go ahead, the fee covers the visit.
What if you find something unexpected once work starts?
The estimate is based on what can be seen. Anything found once a wall, floor or the ground is open is shown to you, priced and approved before it is done.
