What sump pump installation typically costs
| Pump replaced, supplied and installed | $1,489–$2,989The pump itself is most of the difference. |
|---|
Typical prices in Metro Vancouver and the Fraser Valley in 2026, before tax. They are a guide, not our quote. Too much depends on your home to price these jobs unseen, so your price is set on site, in writing, before any work starts.
When you need it
- The pump runs but the water level does not drop
- The pump is silent while the sump fills
- The pump is more than 10 years old and a wet season is coming
What changes the price
| Pump size | A sewage ejector or a high-volume pump costs more than a standard sump pump. |
|---|---|
| Backup | A battery backup or second pump protects you in a power failure, and adds cost. |
| Electrical | The pump needs a proper outlet nearby. If there is none, one has to be added. |
What the job involves
- Test the old pump and float, and clear silt from the sump.
- Fit the new pump with a check valve, so water does not run back in.
- Set the float switch so the pump starts and stops at the right levels.
- Fill the sump and run it through several cycles. Add a high-water alarm or battery backup if you want one.
- Time on site
- Usually 1 to 3 hours
How pricing works for this job
There is no one price for sump pump installation, because the factors above change it from one home to the next. It starts with an on-site estimate for $269. A Pure Mechanical Group plumber looks at the job and gives you a price in writing, good for 30 days. Approve it and the $269 comes off the price. If you do not go ahead, the fee covers the visit. Anything found once work has started is priced and approved before it is done.
Call 1-800-604-0631.
Read next
Questions people ask
How much does sump pump installation cost in Metro Vancouver?
Pump replaced, supplied and installed: $1,489–$2,989. Typical prices in Metro Vancouver and the Fraser Valley in 2026, before tax. They are a guide, not our quote. Too much depends on your home to price these jobs unseen, so your price is set on site, in writing, before any work starts.
How long does a sump pump last?
Around ten years is typical. Silt, constant running and a stuck float shorten it.
Do I need a battery backup?
The pump is needed most in a storm, which is when power fails. If a flooded basement would be costly, a backup is cheap insurance.
My pump runs all the time. Is that a problem?
It may be a stuck float, a failed check valve letting water back in, or a pump too small for the inflow. It will burn out early, so have it looked at.
Is the estimate free?
No. A Pure Mechanical Group plumber comes out, looks at the job and gives you a written estimate. Approve it and the $269 comes off the price. If you do not go ahead, the fee covers the visit.
What if you find something unexpected once work starts?
The estimate is based on what can be seen. Anything found once a wall, floor or the ground is open is shown to you, priced and approved before it is done.
